Choosing the right spray gun?

If you’re starting out looking for a hobbyist spray gun or you’re a professional sprayer getting the right setup configuration can be like, “well where do I start”? or “here’s my wish list of parts”.

Taking into consideration your working space, quality of finish and your budget there can be a lot of questions and queries you might have, for example;

What’s the best compressor for Air fed Masks and Gravity Spray guns running at the same time?
What’s the right fluid tip and nozzle setup for the paint I’m spraying?
Do I need a 3 stage filter?
I need a low noise compressor?
Paint viscosity?
Where to place a drain off point with a rigid pipe configuration?

We’re here to HELP so call (UK TIME 9am – 5pm) +44 (0)1332 611893 or email info@spraygunsdirect.co.uk

For a typical bodyshop / automotive spraying environment we would advise to consider these key points.

One
Air Configuration – Pipework, Filters, drainage, airfed masks and the right compressor.
Two
Preparation – Bodywork, fillers, sanding, masking and panel prep.
Three
Spray gun configuration: gravity feed, pressure or suction feed.
Four
What are you spraying, type of paint and viscosity.
Five
Quality and paint finish expected.
Six
Budget
And finally, brand. (3M, A.N.I. DeVilbiss, Iwata, SATA, Sagola, or Graco)

Common questions…
I have an old gold DeVilbiss spray gun “gti” I need to replace the TE10 Aircap, Fluid Nozzle and Needle?

We stock many discontinued spray gun parts and accessories, look at discontinued spray guns, tap or click your spray gun, you will see a green button to view parts tap or click the button, use the diagram to find the part your looking for, there’s a table below which lets you add parts to your basket.

view Discontinued SprayGuns

If you can’t find your part, please get in touch with our sales team and we will endeavour to get you back up and running.

If you have any questions we’re here to help, our Spray technicians have over 25 years experience and can advise on custom setups and specifications for all spraying needs from model painting, UPVC, automotive, boats, trains, anything… we have years of spraying experience along with expert brand knowledge with a wealth of support for after sales support.

Ways to get in touch…

Call our Spray Guns Direct Team on +44(0)1332 611893
Email info@spraygunsdirect.co.uk

Or use the below enquiry form.